Fingerboard is a fairly new entertainment and hobby, which, despite its exoticism and novelty, has already found hundreds of thousands of fans around the world. Many people are interested in a miniature finger skateboard and tricks that can be performed with it, but not everyone knows where to get this expensive toy, and many simply cannot afford it. Nevertheless, you should not deny yourself the pleasure of owning a fingerboard - it is not difficult to make it yourself.
It is necessary
jigsaw, sandpaper, file, scissors, super glue, lighter, wooden ruler, glass of boiling water, clear varnish, felt-tip pen, pencil, skateboard drawing, rubber
Instructions
Step 1
Take a wooden ruler and draw the outline of the fingerboard on it with a pencil. Its length should be 9.5 cm. Saw out the top and bottom semicircular part of the board with a jigsaw and bring the semicircles to a neat state with a file. Also, with a file on the sides, form concaves (folds along the edges of the board).
Step 2
Determine where the board will fold in the front and back. Mark the folds with a pencil and file them lightly. After that, lower the board into a glass of boiling water, pull it out and slightly break the folds. Dry them over a lighter, and if necessary, pour super glue into the resulting cracks.
Step 3
When the board is dry and the folds are fixed, paint it with paints or felt-tip pens in one bright color. Using fine sandpaper, cut out the outline of the board and glue the emery to the front side.
Step 4
Now open the previously found picture with a drawing on a skateboard and print it on a color printer. Cut out the printed design, glue to the back underside of the board, then varnish with clear varnish and leave to dry.
Step 5
When the fingerboard is dry, start making the wheels and suspension.
To do this, use an elastic band, from which cut out the shock absorbers approximately 1 by 1 cm in size. An axle should be glued to each shock absorber - use for it two sticks sawn off from a round pencil about 2 cm long each.
Step 6
To make wheels, cut 8 circles with a diameter of 0.3 cm from a ruler. Glue them in pairs to make wheels.
Step 7
Glue the axle to the elastic and the wheels to the axle.
Your fingerboard is ready.
