To start installing the motherboard, you first need to open the case and slide it out. This can be done by unscrewing the two case screws holding the side panel. Be sure to place the screws in a prominent place to avoid getting lost. If the case contains a special tray for storing the motherboard, it is better to remove it.
Getting started with the installation
Once you slide the motherboard out slightly, replace its interconnect plate and align with the case. Following this, install the spacers and secure the board well. Pay attention to the material from which the spacers are made. If the spacers are made of copper, you will probably need a tool called a hex to mount them. Then you need to align the holes in the case with the holes on the motherboard. It is very important that they match each other as closely as possible.
You can also install the motherboard correctly at home
After installing the spacers and aligning the holes, you need to secure the motherboard. Screw the screws into the mounting holes located in the center and at the corners. To install the motherboard yourself, you must necessarily connect all the necessary wires and connectors to it. Alternately connect the hard drive (hard drive), the power supply, the button responsible for the reset function, and the speakers to the board. The whole nuance lies in the fact that for different models of motherboards, the slots for all of the above devices are located in different places. If you can't find them right away, try to identify them from the documentation that came with the motherboard.
To install the motherboard yourself, don't forget about the power
To complete the installation of the motherboard, you just need to connect the power to it. It is provided by a device called a power supply. He has a lot of wires with special connectors that must be connected to the appropriate slots. To install the motherboard correctly, check all your steps against the documentation that came with it.
After completing the installation, check again that all wires are securely connected. The connectors should fit into their slots as tightly as possible. After that, you can make a test run of the computer and visually assess whether all the elements connected to the board are functioning. This completes the installation of the motherboard.
