The motherboard is the backbone of every personal computer. It is to it that all components are connected, which means that the procedure for installing it must be approached as responsibly as possible.
The correct choice and installation of a motherboard is the key to the successful operation of a personal computer. The procedure for installing a new motherboard itself takes only a few minutes, but everything must be done as carefully and carefully as possible.
Preliminary actions
First you need to remove the cover of the system unit and open the computer case. As a result, there is full access to the tray for placing the motherboard. For convenience, you can remove the motherboard panel from the computer case. This will allow you to install the device in the appropriate slot without any problems and without the need to work in an uncomfortable position. Unfortunately, not in all system units this panel can be detached. If there is one, you will need a Phillips screwdriver to loosen the screws and remove it. It should be noted that installing a new motherboard usually means assembling a completely new computer. If you upgrade the old one, then you will need to reinstall the operating system and completely format the hard drive, having previously saved all important information.
Safety and last steps
In order to be safe while working with the inside of the computer, it is necessary to discharge the electrostatic discharge that you may have by simply touching the tap water. It is advisable to wear an antistatic wrist strap when working with the inside of the computer so as not to damage the equipment.
First of all, you need to replace the connector panel on the back of the system unit. The new panel comes with the motherboard, so there is no need to find and buy it. You need to make sure that the panel is installed correctly (you need to compare with the connectors on the motherboard). To install a new one, press on all four corners of the panel to firmly seat it in the housing. In addition, special racks should be included with the motherboard, which are also desirable to be installed.
Next, the motherboard is installed on these racks. The holes in the board and the posts must be aligned with each other. Then you can tighten the bolts. It should be remembered that you do not need to tighten them too much, and it is also undesirable to secure the motherboard with an electric screwdriver. Holes that are not metal must be covered with cardboard washers to separate the bolts from the board. Then you can start connecting and installing various components.
