When setting up a wireless network, consider the size of its coverage area. A low signal level usually negatively affects the speed of access to the Internet or other local resources.
Necessary
- - Copper cable;
- - metal curtain;
- - system unit.
Instructions
Step 1
Many Wi-Fi routers have a detachable antenna. Its purpose is to transmit a signal to other devices. To increase the coverage area of the wireless network, it is necessary to replace the standard antenna with a more powerful analogue. Purchase a device that has the correct port to connect to the router. Make sure in advance that the selected antenna is compatible with the equipment you are using.
Step 2
Connect the new antenna by screwing it into the desired port. In the event that the router uses two antennas at once, then it is better to replace both elements. The fact is that they are usually used to broadcast signals at different frequencies. Those. by replacing one antenna, you can increase the range of the 802.11g signal instead of n.
Step 3
Instead of new antennas, you can also use improvised means. To create a high-quality directional signal, use the wall of the system unit. Remove the insulation from the router antenna. Solder a copper wire to it. Connect its other end to the block wall. Naturally, first remove it from the case.
Step 4
The connection must be made with the smaller side of the wall. Install it so that the opposite side is towards the Wi-Fi signal receiving device. If you decide to return the housing wall to its place, be sure to first disconnect the antenna cable from it.
Step 5
Another way to increase the signal coverage is to connect the router's antenna to a metal curtain. In this case, one should not hope for a significant gain in the directional signal. Sometimes this method allows you to expand the Wi-Fi zone by 5-10 meters.
