The AUX input in car radio tape recorders is most often installed to connect external audio devices as a media player or use a speaker system as a headset. This is quite convenient, considering that most mobile devices and portable players use the mini-jack connector.
Necessary
- - plume;
- - wire with plug;
- - various details at your discretion for the implementation of the design.
Instructions
Step 1
Prepare the tools required to install the AUX input in your car radio. To do this, find the ATA33 0 IDE cable and a cable with a shielded mini-jack plug for connection. You can choose any loop, however, the above option is ideal for execution in this case - its thickness is ideally suited to the diameter, thereby eliminating the possibility of short circuits during careless soldering. All the necessary accessories can be purchased at the points of sale of radio equipment in your city. It is best to choose wires made of high-quality materials for these purposes, since there is a high probability of spoiling the equipment.
Step 2
Remove your radio from the car after removing the front panel. Unscrew the screws holding it and disconnect from the power source. Locate the connector on the bottom right corner of the device. Cut the cable of your choice exactly in half, then solder the cable in the place with the mini-jack plugs.
Step 3
It is best not to solder the connector as you may damage the device. If you have not done this before, contact the service centers, where specialists who have repeatedly encountered such changes will do it for you. The best option would be to learn how to make such an input on an unnecessary radio tape recorder.
Step 4
After completing the necessary operations, install your radio in the car so that the AUX-input wires do not interfere with other devices.
Step 5
After that, without fixing the panels, check the input you have set by connecting a portable player or a mobile phone with the appropriate connectors to it. Bring it to the front panel, then fix the position of the car radio with screws. It is best to use self-tapping screws for these purposes.
