How To Remove Overclocking

Table of contents:

How To Remove Overclocking
How To Remove Overclocking

Video: How To Remove Overclocking

Video: How To Remove Overclocking
Video: How to fix a bad overclock on any Video Card 2024, November
Anonim

To increase the power of the computer, a number of operations must be performed. Considering the fact that you need to change the parameters of the processor and RAM, you need to act very carefully.

How to remove overclocking
How to remove overclocking

Necessary

  • - Screwdriver;
  • - tweezers.

Instructions

Step 1

Turn on your computer (laptop) and hold the Delete key to enter the motherboard BIOS. Then press the Ctrl and F1 keys to open an additional menu of device options.

Step 2

Now find the item responsible for the state of the RAM. Reduce the frequency of the bus through which information is supplied to the RAM to the minimum value. This will prevent the bus frequency from increasing during overclocking.

Step 3

Now open the menu responsible for configuring CPU parameters. Increase the processor bus frequency by 10-20 Hz. If the bus frequency has already reached the maximum bar, then increase the processor multiplier by one.

Step 4

Save the settings for these items and restart the computer by clicking the Save & Exit button. If, after the overclocking procedure, the computer stops booting, repeat the procedure for entering the BIOS menu.

Step 5

Repeat the operations inverse to those described in the second and third steps. Those. increase the bus frequency of the RAM and decrease the frequency of the processor.

Step 6

If you are not sure about the correctness of the entered settings, then find the Use Default Settings item or its equivalent, select it and press the Enter key. This will reset the BIOS menu options to their factory defaults.

Step 7

If, after overclocking the computer, it stops loading at all, i.e. you can not even enter the BIOS menu, then manually reset the computer settings. Turn it off and open the system unit.

Step 8

Find the BIOS battery located on the motherboard. Remove it from the socket using tweezers or a screwdriver. Use these tools to close the contacts to which the battery was attached. Put it back in the slot and turn on the computer. Install the CPU-Z program and make sure your processor is stable.

Recommended: