Printer users are sometimes forced to replace cartridges, because constantly buying a new cartridge when the old one runs out is hitting the finances hard. It is much more profitable to simply refill and reinstall the cartridge. Even a beginner will be able to cope with this task.
Necessary
Several cotton swabs, gloves, tissue paper and a cartridge refill kit
Instructions
Step 1
It doesn't take much time to refill the printer cartridge. For this procedure, you will need several cotton swabs, gloves, a tissue paper, and a cartridge refill kit.
First, open the cover and remove the empty cartridge from the printer. This procedure must be carried out carefully, according to the instructions that come with the printer.
Next, you should find a hole for refueling on the cartridge, insert the syringe needle (you can feel a slight resistance, do not worry - this is a porous sponge that is inside) and slowly, at intervals, so that the sponge has time to absorb, pour ink into the cartridge. You need to fill in until ink appears in the drainage hole. Then remove the syringe.
Step 2
It is recommended to wipe the filling and drainage openings with a cloth.
After you have cleaned the holes, it is advisable to seal them tightly with adhesive tape so that air does not get inside the cartridge and ink does not leak out. When you are finished priming, detach the needle and syringe and rinse thoroughly.
Step 3
Place the cartridge on a table to allow it to settle. This will take about 3-5 minutes.
Install the cartridge into the printer, but first remove the adhesive tape from the fill and drain ports. To install, you need to carefully take the cartridge with two fingers and install it in its original place until it clicks lightly.
You have installed the cartridge in the printer. Now it is advisable to turn on the "cleaning cycle" mode. This cycle needs to be run several times until you get good print quality.
As you can see, there is nothing difficult in replacing the cartridge. You saved a little bit of money than if you took it to the workshop, and accelerated the process, because repairs in the workshop take time.
