When buying a computer, the average user usually pays attention to the main characteristics of the system unit: processor frequency, RAM size, hard disk capacity, video card power. The parameters of an optical drive and many other components are often found out only during the operation of a computer. If for some reason the optical drive does not work for you, it is best to have it replaced at a service center.
Necessary
- - crosshead screwdriver;
- - knife.
Instructions
Step 1
If you decide to replace the drive yourself, first of all, completely de-energize the computer and remove all metal jewelry. This is for your safety.
Step 2
Disconnect all cables from the system unit and place it in a convenient place for work. Use a Phillips screwdriver to remove the screws on the back of the system unit that secure the side case covers.
Step 3
Remove both side housing covers as the optical drive is fixed on the frame brackets on both sides.
Step 4
Please note that all optical drive connector connections are likely to be sealed with epoxy or silicone sealant. To disconnect the cables and cables from the device you want to replace, the seal will have to be cut off. Please note that this will automatically void your entitlement to warranty service for your computer.
Step 5
It is quite difficult to make a mistake when connecting wires, tk. they all have different plugs, but if you are still in doubt, it is better to sketch the connection diagram before you disconnect them. In this case, it is recommended to stick pieces of masking tape or stickers on the upper surfaces of the plugs. This will ensure the correct connection of the loops to the new device.
Step 6
Now, disconnect all cables from the drive and unscrew the screws securing it to the frame of the system unit. You will see that the drive can move freely on the brackets. Slide it out of the system unit and insert a new one.
Step 7
Screw it partially to the frame with screws for easy fit. When you align the drive exactly with the front bezel of the computer, the screws can be tightened all the way. However, do not rush to this: it is more convenient to connect cables when the device is not rigidly fixed.
Step 8
Connect cables and cables to the new optical drive according to the diagram. Pay special attention to ensuring that all the stickers are on top. Otherwise, you can damage the contact feet both on the plugs and on the actuator itself.
Step 9
When all the necessary cables are connected, align the optical drive with the front panel of the system unit and tighten the mounting screws all the way. Install and secure the side housing covers. Connect the cables for the monitor and other peripheral devices. Turn on your computer.
Step 10
After the operating system boots, it detects new hardware, recognizes it as a CD-ROM drive, and installs the most appropriate drivers for it. The optical drive is now ready for use. However, if a special disk was included with the device, it is better to reinstall the drivers from it - with the “native” software, the CD-ROM will have much more capabilities and work much more efficiently.
