How To Refill Cartridges

Table of contents:

How To Refill Cartridges
How To Refill Cartridges

Video: How To Refill Cartridges

Video: How To Refill Cartridges
Video: how to refill 12a cartrage in hindi / HP Laserjet P1005 Toner Cartridge Refill 2024, December
Anonim

A cartridge is an element of a printing device (copier, MFP, printer) that contains ink / toner. The print cartridges are designed for different page counts for different printers. You can refuel it at home too.

How to refill cartridges
How to refill cartridges

It is necessary

  • - cartridge;
  • - toner.

Instructions

Step 1

Refill a Canon cartridge. If you have a BC-20 type, it can be refueled through the vent located on the side. Expand it a little, insert a needle into it, pump ink into the cartridge. You should not glue this hole.

Step 2

To refill a BC-21 cartridge, seal the outlet openings with adhesive tape, then carefully remove the top cover. There are filling holes under the cap, pump ink into them, for this, immerse the needle to the middle of the cartridge. Replace the cover and wrap it with tape. Use another method of refilling the cartridges, at the bottom of each of them there is a membrane. Slowly drip ink onto it, it will be absorbed.

Step 3

Refill the HP LaserJet cartridge using Static toner. Remove the spring that holds the cartridge halves together. Use tweezers for this. Unscrew the two screws on the cover, remove the cover and take out the drum. Wipe it with a soft dry cloth, wrap it in a cloth, and hide it in a dark place while refilling the HP cartridge.

Step 4

Grasp the shaft by the metal shaft and wipe with a rag to remove any burnt toner. Set it aside. Push the pins outward. Take them out and set them aside. Unscrew the two bolts that secure the cleaning blade. Take it off. Empty the waste toner. Install the shaft. Remove the cover opposite the gears. Pour toner through the hole, do not make any sudden movements.

Step 5

Note that refilling toner is similar to filling a glass with champagne, warm and shaken. Hold the magnetic roller to prevent toner from spilling out. Close the hopper with a stopper, put on the lid. Tighten the screw. Connect the halves, insert the pins. Insert the drum. Apply a thin layer of toner to the roller. Put on the cover and replace the two bolts and the spring. To refuel other types of cartridges, use the articles posted on the website kartrige.com.ua.

Recommended: