How To Connect Twisted Pair

Table of contents:

How To Connect Twisted Pair
How To Connect Twisted Pair

Video: How To Connect Twisted Pair

Video: How To Connect Twisted Pair
Video: How To Make RJ45 Network Patch Cables - Cat 5E and Cat 6 2024, March
Anonim

Sometimes there are situations when it is necessary to increase the length of the network cable. In such cases, it is customary to use special devices or build up the twisted pair yourself.

How to connect twisted pair
How to connect twisted pair

It is necessary

knife, electrical tape, connector

Instructions

Step 1

One of the simplest and most rational options for connecting network cables is to use a connector. There are special miniature switches containing two or three LAN ports. Connect both network cables to it to connect them.

Step 2

If you absolutely do not want to purchase additional equipment, or there is simply no such possibility, connect the network cables yourself. Cut one end of each cable.

Step 3

Remove the outer insulation from a small section of the power cable. You will see eight different colored braided wires. Strip the insulation from each wire.

Step 4

Do this in such a way that you can see the braid colors of each individual element. Do not cut the wires at the same level. If you peeled, say, twelve centimeters of cable, each wire should be 2, 4, 6 cm, and so on.

Step 5

Remove the braid from the second cable in the same way. In this case, you need to cut the wires so that their length is inversely proportional to the length of the wires of the first cable. Those. if the length of the blue wire of the first cable is 4 cm, the length of the second wire should be 8 cm.

Step 6

Connect each wire in pairs to its counterpart. Insulate each such twist with special tape. Also wrap the common joint with insulating tape to prevent breakage of the twists.

Recommended: