Apex is a file-sharing system that is built on the latest version of the dc ++ file-sharing program. In comparison, Apex dc ++ contains improvements and improvements, is flexible in configuration, and also has support for the Nextpeer network.
Necessary
- - Computer with Internet access;
- - installed Apex program.
Instructions
Step 1
Close all open folders to prepare the Apex setup. Next, download the Apex DC ++ program, for this follow the link ftp://vpn.beatle.net.ua/Install/Network/DC/ApexDC/ApexDC.rar, download the archive and unpack it to any folder on your computer. Run the installation file, wait for the installation to finish. After the program starts, a window will appear, enter a nickname in it, raise the upload speed in the Line speed (Upload) field
Step 2
To configure downloads in Apex, go to the Downloads submenu, specify the path of two Directories lines (download folders): for ready-made downloads, specify the path in the Default download directory line, and for unfinished downloads, in the Unfinished downloads directory line. Specify, if possible, the folder for the finished files, the same one that will be opened for sharing (downloading).
Step 3
Continue configuring Apex, in the settings window select the Sharing item on the left side, find and select folders with a total size of at least 2 gigabytes on the right side of the window, check the box next to them. If you select a folder less than 2 gigabytes, then the hubs may not perceive it.
Step 4
Click on the checkbox, a window will appear in which you specify the name of this folder in the distribution, you can just click on the "OK" button. Next, the program will index the files, wait for it to complete.
Step 5
Search for the required files in the program, for this use the key combination Ctrl + S. Customize the appearance of Apex, for example, Russify it. Go to Settings, select Appearance, click on the Browse button.
Step 6
In the window that opens, specify the path to the folder from which the program was installed, from there select the russian.xtml file and open it. Next, restart the program to change the appearance of Apex.
Step 7
Connect to the hub, to do this, click the button with the asterisk, in the "Favorite hubs" window, click "New", in the properties of the hub, enter its name and specify the address of the required hub. The rest of the fields are optional. Click OK. A new hub will appear in the window of the selected hubs, then check the box next to the hub and restart the program. Apex DC ++ setup is complete.
