Pantera alarm is one of the leaders in the modern Russian market of car anti-theft systems. It has rich functionality and system configuration capabilities, as well as various configurations that differ in the number of tasks performed and the price for a set of equipment. The owner of the Pantera anti-theft system can program up to 4 transmitters at a time, which makes the alarm not only effective, but also comfortable to use.
Necessary
instructions for the Pantera alarm
Instructions
Step 1
Prepare to program the theft deterrent transmitter. To do this, disarm the alarm and get into the car.
Step 2
Check if the system shutdown function is enabled using the Valet override button. If the function does not work, then you need to enter the security system menu. However, it will not be easy to get into the settings, since they are protected from the penetration of unauthorized persons, which is very reasonable, since otherwise any attacker could easily change the parameters of the security perimeter and gain access to the vehicle.
Step 3
Enter your personal code to access the alarm programming menu. If you have never entered a code before, use the preset serial number, which can only be entered once. It is assumed that the vehicle owner should take care of setting his own security code as soon as possible.
Step 4
Start the car, turn off the ignition, and then start the engine again. After that, within 15 seconds, press the Valet button a certain number of times equal to the first digit of the security code. If you do not meet the allotted time, repeat the entire procedure, starting with ignition.
Step 5
If the individual code consists of two or more digits, press Valet to enter the rest of the digits as well, adhering to a rigid time schedule.
Step 6
After the last digit of the code has been entered and the ignition is turned off for 10-15 seconds, press the secret button three times. Please note that after this the alarm siren of the security system must sound and the LED must start blinking rapidly.
Step 7
Press and hold the transmitter button. Another siren signal should inform the owner of the Pantera alarm that the transmitter has been programmed successfully. Then you can start programming another remote control, again focusing on the 15-second time interval.
Step 8
To exit the security system programming mode, simply start the car engine or do not press the service function control buttons. The alarm will give one short and one long signal, notifying the owner of the car about changes in the operation of the system, after which it will switch to the security mode itself.
