Many users prefer refilling cartridges to replacing a new one, since this option is much cheaper. Refueling can be done both at the service center and on your own.
It is necessary
- - crosshead screwdriver;
- - lint-free napkin;
- - ink.
Instructions
Step 1
Open the printer cover and remove the cartridge from there. Look at the side of it and find the largest bolt that secures it. Unscrew it with a Phillips screwdriver.
Step 2
Remove the cover, while being extremely careful and careful not to lose the spring. Make sure it stays in place.
Step 3
Release the retaining tabs on the cartridge while moving one part of the cartridge relative to the other. After that, open it and very carefully so as not to scratch the surface, remove the drum from it. Pay attention to its working condition - if it is worn out, it is best to buy a new one, because this can affect the overall print quality of the printer.
Step 4
Remove the charge roller from the second half of the cartridge. Wipe it off with a paper towel or other lint-free soft cloth. Remove the two screws holding the cleaning blade and wipe it down as well.
Step 5
Clean the waste toner box. Use a cotton swab to clean the ink from the cartridge parts.
Step 6
Unscrew the screw, remove the cartridge side cover. There you will see a small magnetic shaft with sleeve bearings, and be sure to clean this part as well.
Step 7
Remove two more screws holding the metering blade. Remove it, fill it with the appropriate brand of toner. If you refill the starter cartridge that came with the printer when you bought it, add no more than 65 grams of powder. If the cartridge is standard, then about 85 grams.
Step 8
Assemble the cartridge by joining the parts together and inserting the tubular hinge parts from both sides. Put both springs in their places, fix all the parts by screwing them tightly with the side covers.
Step 9
After you put the spring back in place, check if the camera compartment is working - it should open and close freely.
Step 10
Insert the cartridge into the printer, print a test page.