Many people want to make their computer a Wi-Fi hotspot. This allows other devices to be connected to it. Modern technologies allow this operation to be carried out in a few minutes. However, first you should configure all the parameters so that the system will allow the connection operation.
Necessary
Personal computer or laptop, internet
Instructions
Step 1
To create an access point, you first need to tackle the settings. Disable temporarily your antivirus protection system. Disable Windows Firewall too. Check all settings.
Step 2
For example, you can use D-Link DSL-G604T devices. Connect it to the network card of your computer. D-Link DSL-G604T has an IP address “192.168.1.1”. Open the properties of your computer's network connection and set an I-address that is different from the IP address “192.168.1.1”. Open Internet Explorer. Enter “https://192.168.1.1”. Enter your username and leave no password. Now set up your wireless network. Make sure the DHCP server is enabled. IP-addresses will all fit those that are set in the program by default. Supply the address of the domain name server - DNS. Set the primary DNS address of your ISP. Click “Apply” to save the settings. Select “Wireless Setting”.
Step 3
Now you can set the parameters of the wireless access point. It is necessary to enable a check mark on the "Enable AP" item. Assign a non-obvious SSID. Turn off the SSID broadcast on the radio. Select an encryption method such as “WPA”. Click to save "Apply". Insert the driver disk for the wireless network adapter. Install it on your computer. Insert the DWL-G650 + adapter into the “CardBus” slot. Complete the driver installation. Go to the properties of the wireless connection. Set "Obtain an IP address automatically", as well as "Obtain DNS server address automatically".
Step 4
Go to the "Wireless Networks" tab. Uncheck the box next to Use for Wireless Configuration. Configure the wireless adapter. To do this, you need the D-Link AirPlus G + Wireless Adapter Utility. Enter the same SSID. Set the "Wireless Mode" to "Infrastructure". Click the "Apply" button. Configure the security and encryption setting. Save the settings back.
