The more devices are connected to your computer, the more acute is the question of where to remove the constantly tangled, dusty wires. If you are unable to replace your devices with wireless devices, use several methods below.
Necessary
- - a hammer;
- - cable clamps;
- - box.
Instructions
Step 1
Nail the wires around the perimeter of the room to the baseboard using brackets available at any hardware store. They are small and invisible at first glance, so they are the best suited for these purposes. However, this is convenient if you have 1-2 cables, and if there are more of them, then the best solution to the problem would be to lay the wires in special boxes. Also, the wires can be hidden under the skirting board, if it is not a problem for you to unscrew it and then put it back in place.
Step 2
Find a small shoebox. Make several small cuts on one side according to the number of wires under the table. Pay attention to the small, long boxes that you sometimes find at the hardware store, they can also be used for the same purpose.
Step 3
Disconnect the computer wires for a while, pass them through the holes made in the box. Roll up the excess, secure with a special wire and or simply place them in a box, but in this case, there is a chance that each time you will spend a lot of time untangling them. Pull the ends of the wires through the holes made on the other side and close the cover.
Step 4
Reconnect the wires to the computer, removing the box under the table, on the system unit or in any other place where it will not interfere.
Step 5
If you have a lot of wires going along the same route, use the special corrugated tubing available at hardware stores. Also a convenient option for conducting network wires is to lay them in the wall and install a power outlet.
Step 6
Pay attention to the new models of tables, the design of which provides for laying wires in specially designated places in such a way that they are absolutely invisible and do not interfere with cleaning the apartment.
