Often people are faced with the problem of lack of information on the disassembly of a particular technique. This is primarily due to the fact that manufacturers provide such instructions exclusively to qualified service center specialists. Most Acer laptop models have similar assembly schemes, so step-by-step instructions will be relevant for most laptop users of this company.
Necessary
- - screwdriver;
- - not a sharp knife.
Instructions
Step 1
Disconnect the computer from the power source. Turn the laptop right side down, remove all screws on the back cover. After removing all the detachable elements of the cover, you will see inside the hard drive bolted to the case and secured with a metal plate - also remove all fasteners to remove it.
Step 2
From the board located to the right of the hard drive, carefully disconnect the two wires attached to it, usually they are black, the other white. Then disconnect the board itself from the computer.
Step 3
Set the screwdriver aside. The next part will be the most difficult and requires a lot of care from you. Removal of the bottom panel located in front of the monitor is done with a knife. Make sure it is not too sharp beforehand to avoid damaging the surface. Then gently pry the cover on both sides of the laptop, one at a time, and remove it. Please note that you need to be extremely careful especially with this part of the computer - it is very easy to break it. Therefore, do not make much effort to disconnect it, it is very easy to remove without it. Then remove the screws securing the keyboard and disconnect the ribbon cable.
Step 4
Under the removed panel, you will find the wires connecting the monitor to the computer. Unplug the monitor cord from the white connector, and then, after removing the keyboard, remove the black wire underneath it leading to the screen. Remove both screws that secure the monitor to the case, then you can remove it.
Step 5
Disconnect the wires from the "touchpad" - the touch-pointing device panel and then remove the motherboard from the computer case. It is much more convenient to remove the cover from the side of the monitor, having previously removed the connectors of the device that determines the position of the computer cover. Done - you've taken apart your Acer laptop. Its further assembly takes place in reverse order.
