Any scheme for connecting an ordinary lamp through a switch can serve as a circuit for connecting an infrared motion sensor, therefore, its installation will be just as simple.
Necessary
- - screwdriver
- - instruction.
Instructions
Step 1
Decide where you will install infrared motion sensors. Make sure there are no power cables nearby. The opposite wall should not have a metallic surface. Make sure that the position of the sensor is stable in the position you have chosen.
Step 2
Unscrew the fasteners from the sensor device, separate its component parts - the back cover and the board. Attach the back cover to the wall at the position you specified for installing the sensor. Use a pencil to mark the points where the device is attached to the surface Drill holes, fix the base of the device with bolts and install the board.
Step 3
Install the LED jumpers. Then set the number of pulses switch, here the values for its positions may vary depending on the model you are using. Proceed to remove the insulation film and wait for the battery to turn on. Set the panel to enrollment mode. Press the tamper and the code learning button, thereby registering the address code.
Step 4
Set the motion detection angle of the sensor. In this case, be guided by such a factor as the possibility of having animals in the room. Please note that at a certain angle in some models of sensors, the sensitivity to animals changes up to 10-20 kilograms. Test the installed device. Walk around the perimeter of the entire room, making sure the sensor position is in the center of the motion detection area.
Step 5
Please note that after activating the sensor, you, depending on the model, will have a strictly defined time for testing. Read the instructions carefully, paying attention to the features of the device, as they may differ for each model.
